Make your own free website on Tripod.com
Up ] Docs Home ]

LIDT - Load Interrupt Descriptor Table Register

Back ] Next ]

*

A

B

C

D

E

F

G

H

I

J

K

L

M

N

O

P

Q

R

S

T

U

V

W

X

Y

Z

?


Code Mnemonic Description
0F 01 /2 LGDT m16 & 32 Load m into GDTR
0F 01 /3 LIDT m16 & 32 Load m into IDTR

Description
Loads the values in the source operand into the global descriptor table register (GDTR) or the interrupt descriptor table register (IDTR). The source operand specifies a 6-byte memory location that contains the base address (a linear address) and the limit (size of table in bytes) of the global descriptor table (GDT) or the interrupt descriptor table (IDT). If operand-size attribute is 32 bits, a 16-bit limit (lower 2 bytes of the 6-byte data operand) and a 32-bit base address (upper 4 bytes of the data operand) are loaded into the register. If the operand-size attribute is 16 bits, a 16-bit limit (lower 2 bytes) and a 24-bit base address (third, fourth, and fifth byte) are loaded. Here, the high-order byte of the operand is not used and the high-order byte of the base address in the GDTR or IDTR is filled with zeros.

The LGDT and LIDT instructions are used only in operating-system software; they are not used in application programs. They are the only instructions that directly load a linear address (that is, not a segment-relative address) and a limit in protected mode. They are commonly executed in real-address mode to allow processor initialization prior to switching to protected mode.
Operands Bytes Clocks
mem48 5 6 NP

Flags
ID unaffected DF unaffected
VIP unaffected IF unaffected
VIF unaffected TF unaffected
AC unaffected SF unaffected
VM unaffected ZF unaffected
RF unaffected AF unaffected
NT unaffected PF unaffected
IOPL unaffected CF unaffected
OF unaffected